Where To Rent Mining Pump Equipment Across Fresno California

Belt-Press Description

BP-1900 2.2 Meter Mining Belt Press Rental in Fresno, CA. This is a BP-1900 mining belt filter press rental requires a 480 three phase 100 amp breaker power supply. Belt Press rentals and thickeners size range from 1.2 meter to 3.2 meter wide belts and are mounted with full polymer, belt was, belt drive and belt tracking systems. A Belt Filter Press is an industrial machine, used for solid/liquid separation processes, particularly the dewatering of sludges in the chemical industry, mining and water treatment. The process of filtration is primarily obtained by passing a pair of filtering cloths and belts through a system of rollers. These belt press systems are commonly used for Sanitation and Sanitation Districts, Water Treatment Plants and Wastewater Treatment Plants. Aspen Rentals provides the highest quality dewatering rental equipment for municipal and industrial clients in Fresno, Clovis, Sanger, Selma, Kerman, Parlier, Kingsburg, Reedley, Madera, Dinuba, Orange Cove, Hanford and all of California.

This is a BP-1900 2.2 meter mining belt filter press rental and requires a 480 three phase 100 amp breaker power supply. It also has a water requirement of fresh water that needs to be pumped at 109 GPM and 35+ PSI.

Specific Dewatering and Wastewater Management Unit Description:
-Trailer mounted unit
-Automated flash building polymer unit
-Sludge feed pump
-Electronic controls (hydraulic on belt drive and pump)
-Flow meter
-All VFD controls
-Sludge discharge auger (7.5 ft. high and 4 ft. out)

Most Belt Filter Press operations can be divided into three general stages - first is the initial de-watering, which makes the sludge pulp; then you have the pressing or medium pressure filtration, which conditions the sludge for high pressure filtration quality; and lastly you have the high pressure filtration, which raises the dry solids content in the sludge cake to the optimum level.

The process begins as the sludge enters the press, where it is mixed with a chemical , either in the press, or in a conditioning tank prior to the press. From this flocculation or preparation zone the sludge enters the gravity drainage zone, where a large rotating drum agitates the floc and drains approximately 70% of the free water. The resulting capture rate can be as high as 99%.

Pressure is first applied in a low pressure wedge zone, which begins squeezing remaining water out of the sludge. Further dewatering occurs in the medium pressure zone, where two large perforated drums of decreasing size apply the pressure. Rollers perform the final dewatering in the high pressure zone. The sludge cake (filtered solids) then exits the machine. The belting on a belt filter press must be continuously washed with clear water to keep it from blinding, and this is accomplished by water spray bars placed above returning belt.

To Learn More About Renting A Mobile Belt Filter Press Please Give Us A Call Today

No matter the size of the dewatering project Vapor Industries can deliver the correct mobile belt press machine rental for your jobesite. Any questions please give us a call

For additional information you can view this item at Aspen Rentals or you can use the contact form below.