| |
|
|
| |
More by
Aspen Rentals-Tampa FL Mobile Belt Press
|
|
| |
|
|
|
| |
Equipment Description
Tampa Wastewater Pumping Rentals-BP 5100 Extended Gravity Zone Belt Press For Rent-Florida Dewatering Rental Equipment
BP 5100 Extended Gravity Zone Belt Press Rental in Tampa, FL. This is a Ashbrook 2.2 meter belt filter press on a 27' 7" long skid with an automated polymer system for emulsion polymers. Belt Press rentals and thickeners size range from 1.2 meter to 3.2 meter wide belts and are mounted with full polymer, belt was, belt drive and belt tracking systems. A Belt Filter Press is an industrial machine, used for solid/liquid separation processes, particularly the dewatering of sludges in the chemical industry, mining and water treatment. The process of filtration is primarily obtained by passing a pair of filtering cloths and belts through a system of rollers. These belt press systems are commonly used for Sanitation and Sanitation Districts, Water Treatment Plants and Wastewater Treatment Plants. Aspen Rentals provides the highest quality dewatering rental equipment for municipal and industrial clients in Tampa, St. Petersburg, Clearwater, Sarasota, Cape Coral, Naples, Port Charlotte, Brandenton, Bonita Springs, Fort Myers, Fort Myers Beach, Pine Island, Crystal Beach, Indian Rocks Beach, Belleair Beach, Medeira Beach, St. Pete Beach, Holmes Beach, Bradenton Beach and all of Florida.
This is the BP-5100 Ashbrook 2.2 meter Extended Gravity Zone belt press rental. The unit is mounted on a 27' 7" long skid. This unit is mounted on a heavy duty industrial skid with a gravity belly pan
Specific Dewatering and Wastewater Management Unit Description:
- Automated polymer system for emulsion polymers
- Sludge feed pump
- Variable frequency electronic controls and auto kill switches
- Belt misalignment and emergency stops
- Press requires a 480 three phase, 100 amp breaker power supply
- Water requirements are fresh water at 100 gpm and 35+ psi
- Hoses for sludge feed are available upon request
- Screw auger that discharges approx 3.5 up and 3 feet out from the press
Unit Specs:
9' 2" high, 11' 10" wide, 27' 7" long, 32,000lbs (including belt press and all ancillary equipment)
Most Belt Filter Press operations can be divided into three general stages - first is the initial de-watering, which makes the sludge pulp; then you have the pressing or medium pressure filtration, which conditions the sludge for high pressure filtration quality; and lastly you have the high pressure filtration, which raises the dry solids content in the sludge cake to the optimum level.
The process begins as the sludge enters the press, where it is mixed with a chemical , either in the press, or in a conditioning tank prior to the press. From this flocculation or preparation zone the sludge enters the gravity drainage zone, where a large rotating drum agitates the floc and drains approximately 70% of the free water. The resulting capture rate can be as high as 99%.
Pressure is first applied in a low pressure wedge zone, which begins squeezing remaining water out of the sludge. Further dewatering occurs in the medium pressure zone, where two large perforated drums of decreasing size apply the pressure. Rollers perform the final dewatering in the high pressure zone. The sludge cake (filtered solids) then exits the machine. The belting on a belt filter press must be continuously washed with clear water to keep it from blinding, and this is accomplished by water spray bars placed above returning belt.
For additional information you can view this item
at Aspen Rentals-Tampa FL Mobile Belt Press or
you can use the contact form below.
|
|
Nearby Locations
